Tech Library #1

Dura Bench Original
Plastic Greenhouse Bench Top

The Dura-Bench Original was introduced in 2001 as a plastic bench top to replace wood, wire and expanded metal. The Dura-Bench Original is heavier in weight and encompasses smaller square holes for more surface area. This product is peak load tested at 630 lbs.

DESIGN / FEATURES

• 2'x 4' (8 sq.ft., nominal) high impact abrasion resistant polypropylene plastic panel - weight 6.35 lbs each
• 1.1 " x 1.1" square holes
• Two unique styles - Overlap and Non-Overlap versions
• The Overlap version interconnects with tabs on the 4' sides and overlaps on the 2' ends
• The Non-Overlap version interconnects with tabs on the 4' sides and butts up to the 2' ends
• (10) Pre-molded screw holes per panel for attaching to substructure with stainless steel screws

UNIQUE BENEFITS

• Durable, Flat, Smooth Surface
• Smaller Hole Openings
• Heavier
• Easier to Install
• Easier to Disinfect
• UV Protection
• Longer Lasting
• Rot, Splinter & Decay Proof
• Rust, Corrosion & Deforming Proof

TABLE LAYOUT / DESIGN

• Dura-Bench Ultra panels allow for any combination of bench sizes
• Overlap version is primarily used in 2', 3', 5', 6', 7', and 8' wide benches - the 4' length lays down going in the same direction as the length of the bench
• Non-Overlap version is used primarily on 4' wide benches - the 4' length lays down going across the width of the bench
• Substructure frame can be made from metal, wood, or pipe
• Substructure frame cross supports are placed on incremental intervals of 16" or 24" centers based on the weight of the plants per sq foot

REPLACES

• Expanded Metal
• Wood / Lattice
• Wire

Index Page | Benches | Ebb and Flo Benches | Econo Bench | Rolling BenchesExpanded Metal | Growing Benches | High Density Structural Plastic BenchesStationary Benches | Dura Bench |Dura Bench Ultra
Display Benches Heavy Duty Plastic | Display Systems Metal